SINGER Motor Belt # 193077 , # 198651 15-88,15-90,185k,206k,223,306k,327,328

Description

Up for sale is an original style, Black  V belt  for many Singer vintage models.
Belt part  # 193077 ,Will also replace belt number # 198651.
If you have a Singer 66  series model , make sure it has a solid hand wheel (Not Spoked).
Will Fit
15-90, 66, 99, 206, 306, 319, 327, 328, 329
and many others. Belt  measures 15 3/4" .
New, Softer, better quality Black V-Belt . .   This is the best belt you can buy for your machine. Order as many belts as you wish for the same S&H..
Here are a few more models belt will fit.
Singer 127, 128, 15-88, 15-91, 185, 185k3, 206K, 223, 306k, 306w, 66-1,66-4, 66-6, 66-8, 66-14, 66-16, 66-18, 66-24, 99-13, 99-31  And many more.
Please note:
On certain Singer models , the belt size can vary depending on the stlye motor it has on. Make sure to measure your old belt or wrap a string around your machines pulleys to make sure this is the correct size. The outside circumference of this belt is 15 3/4" .
" Instructions how to measure and verify what size belt you
need "
1* Remove old belt if still attached on machine
2* Adjust motor to center position. Most sewing machine motors have a bolt or screw that holds the motor in place. When this bolt or screw is loosened, the motor will move in two directions. Loosen this screw and move the motor to center position and re-tighten the bolt or screw. The reason for this step is so that you will have about 1/2" worth of adjustment for the new belt .
3* Take a piece of non-stretchable string and run it around the machine's hand wheel and motor pulley. Be sure that the string is inside of the belt groove of the hand wheel and pulley.
4* Cut the string so that two ends meet. This will tell you what size of belt you will need.
5* Remove the string from the machine and lay it flat and straight on a table. Measure the complete length of the cut string. Now you will know what size of belt to order. For example, if the string measures 14 1/2" long, then you will need a 14 1/2" belt.
6*  Once the new belt has arrived, you simply loosen the bolt or screw that is holding the motor in place. Then attach the belt around the hand wheel and pulley. Make sure the belt is inside the belt grooves. You may have to lift or adjust the motor slightly in order to get a good fit. Once the belt is in place, simply apply a little down pressure on the motor while tightening the bolt or screw. The belt should be tight enough so that it doesn't slip, but not too tight so that it puts strain on the motor.
Item will ship First Class with Delivery confirmation. Please e-mail any questions. Thanks